Land Rover Discovery: Jacking and Lifting - Lifting
READ NEXT:
WARNING:
Make sure that the vehicle is stable before commencing work.
CAUTION:
If the drive shaft(s) are to be removed, release the parking brake and
select NEUTRAL 'N' in the transmission in order th
NOTE:
To enable the vehicle to be supported correctly on the wheel-free
longitudinals, it will be necessary to produce 2 off each of the support
blocks to the dimensions given in the accompanying illu
SEE MORE:
The rain/light sensor is located at the upper edge of the windshield, behind
the interior rear view mirror trim panel. Contact between the rain sensor
and windscreen is provided via a silicon pad which is compressed during the
assembly process by two locking retaining clips either side of the sens
PART(S)
REMOVAL
NOTE:
Removal steps in this procedure may contain installation details.
Connect the diagnostic tool and set the electronic park brake (EPB)
to the maintenance position
NOTE:
This step is only required if the diagnostic tool is not
available.
Refer to: Electronic Parking Brake