Land Rover Discovery: Exiting the vehicle
Land Rover Discovery (2009–2016) Owner's Manual / Exiting the vehicle
READ NEXT:
Single locking
Before exiting the vehicle, always
make sure that the correct gear
for parking is selected, the engine
is switched off, the Electric
Parking Brake (EPB) is applied,
and the Smart key is removed
from t
Automatic RE-locking and RE-arming of the alarm
If the vehicle is unlocked with the Smart
key, and a door or the luggage area are
not opened within 40 seconds, all of the
doors will re-lock automatically to the
previous locked state and the alarm w
Door locks and release levers
While a door is open, the locking
latch is exposed. If your vehicle is
fitted with the 'soft close' feature,
do not attempt to manually close
the latch, as it may also
automatically 'soft close' and t
SEE MORE:
Interior Trim and Ornamentation
Loadspace Trim
Panel (G1785138) / Removal and
Installation
PART(S)
REMOVAL
NOTES:
Removal steps in this procedure may contain installation details.
Using a suitable tool, release the trim panel..
Discard the retaining clips.
Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
Open rea
Variable Coolant Pump
Electrical connector - ECM position sensor 5V supply
Electrical connector - shroud control solenoid 12V supply
Position sensor
Variable coolant pump body
Drive pulley hub
Seal
Shroud
Pump impeller
The variable coolant pump is located on the upper left side of the engine
within a cavity i
© 2019-2026 Copyright www.lrdisc.com
