Land Rover Discovery: Navigation system
READ NEXT:
Navigation instruction is by map and turn
information displayed on the Touch screen
and can be complemented by voice
guidance, if required. The system uses
signals from Global Positioning System
(GPS)
The Navigation SD card reader is located
in the front centre cubby box.
Make sure
the SD card is located correctly in the card
reader before operating the Navigation
system.
Note: If for any reason
Where To?: Touch for a list of options
for setting a destination.
Map View: Touch to view the map
screen.
Favourites: Touch to view the list of
stored destinations.
Settings: Touch to
SEE MORE:
Installation
Dress the flanges where necessary.
Offer up the new rear lamp panel outer and clamp into position.
Check alignment, if correct, proceed to next step, if not, rectify and
recheck before proceeding.
Drill holes in the rear lamp panel outer where the metal insert gas
(MIG) plug
Electrical connector - ECM position sensor 5V supply
Electrical connector - shroud control solenoid 12V supply
Position sensor
Variable coolant pump body
Drive pulley hub
Seal
Shroud
Pump impeller
The variable coolant pump is located on the upper left side of the engine
within a cavity i