Land Rover Discovery: Navigation SD card
The Navigation SD card reader is located
in the front centre cubby box.
Make sure
the SD card is located correctly in the card
reader before operating the Navigation
system.
Note: If for any reason the SD card is
ejected while the Navigation system is in
operation, locate the SD card correctly in
the card reader and touch Retry soft key
on the Touch screen, when prompted.
USING THE NAVIGATION
SYSTEM
- In the interests of safety, only
operate, adjust, or view the
system when it is safe to do so.
- The Navigation system is not a
substitute for driving safely, with
due care and attention. Drivers
should not assume that a feature
will correct errors in judgement
when driving. It is the driver's
responsibility to stay alert, drive
safely, and be in control of the
vehicle at all times, relative to the
prevailing conditions. It is also the
driver's responsibility to
determine the safety of the route
suggested by the Navigation
system. The Navigation system
may not function properly in all
circumstances.
- Do not allow the system to
distract the driver while the
vehicle is moving. Driver
distraction can lead to accidents,
causing serious injury or death.
To access the Navigation system, press
the Navigation button or touch the
NAVIGATION area on the HOME screen.
Note: The Navigation system will remain
active until the ignition is switched off and
the driver's door is opened.
This will show the current vehicle position.
Touch the NAV MENU soft key to display
the NAV MENU screen.
At this point, the first time user should set
up personal preferences in the NAV
SET-UP area. These settings are applied,
whenever the Navigation system is used.
READ NEXT:
Where To?: Touch for a list of options
for setting a destination.
Map View: Touch to view the map
screen.
Favourites: Touch to view the list of
stored destinations.
Settings: Touch to
Touch to select the NAV MENU.
Touch to select the ROUTE menu.
Touch to set a selected destination.
Touch to show information for a Point
of Interest (POI), or for traffic
information.
Touch t
To set a destination from the selection of
POIs: In Where To?, touch Point of
Interest to view the following list:
All Categories.
Gas Stations.
Restaurants.
Hotels.
ATM / banking.
Enter Name.
SEE MORE:
REMOVAL
NOTES:
Removal steps in this procedure may contain installation details.
LHD illustration shown, RHD is similar.
CAUTION:
Note the installed position of the component prior to
removal.
Torque: 25 Nm
NOTE:
Do not disassemble further if the component is removed for
access only.
INSTA
PRINCIPLES OF OPERATION
For a detailed description of the Engine Emission Control, refer to the
relevant Description and Operation section in the workshop manual. REFER
to: Engine Emission Control (303-08B Engine Emission Control - INGENIUM
I4 2.0L Diesel, Description and Operation).
INSPECTION AND