REMOVAL
NOTE:
Removal steps in this procedure may contain installation details.
Disconnect the battery earth lead.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
Refe
REMOVAL
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential
information is always correct.
If a new battery i
Operation
When the park brake is applied with the EPB switch, the ABS control
module uses the wheel speed inputs to determine when to use the static
and dynamic modes of operation. It uses the static mode at vehicle speeds
up to 3km/h (2mph) and the dynamic mode at vehicle speeds greater than
3km/h
BATTERY CARE REQUIREMENTS
4 . 1 RECEIPT OF A NEW VEHICLE
Within 72 hours of receipt of a new vehicle, a battery condition check must
be carried out in accordance with the battery test process utilizing a JLR
approved tester as outlined in the Equipment section (Section 5) of this
procedure.
NOTES