Land Rover Discovery: Battery and Charging System
Land Rover Discovery (2009–2016) Service Manual / Electrical / Battery and Charging System
- Auxiliary Battery (G1913471) / Removal and Installation
- Battery (G1774714) / Removal and Installation
- Battery Diagnostics
- Battery, Mounting and Cables/ Description and Operation
- Battery, Mounting and Cables Diagnosis and Testing Battery
- General Information Battery Support Unit Connection Procedure
- General Information Battery Care Requirements
- General Information Charging System / Diagnosis and Testing
- Generator and Regulator
READ NEXT:
Auxiliary Battery (G1913471) /
Removal and
Installation
REMOVAL
NOTE:
Removal steps in this procedure may contain installation details.
Disconnect the battery earth lead.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
Refe
Battery (G1774714) / Removal and
Installation
REMOVAL
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential
information is always correct.
If a new battery i
SEE MORE:
Electronic Engine Controls
- Ingenium i4 2.0l Diesel
Exhaust Gas
Temperature Sensor (G1875930)/ Removal and Installation
REMOVAL
WARNING:
Observe due care when working near a hot exhaust system.
NOTES:
Removal steps in this procedure may contain installation details.
Engine shown removed for clarity.
Refer to: Engine Cover - INGENIUM I4 2.0L Diesel (501-05 Interior
Trim and Ornamentation, Removal and Installation)
Partial Renewal
The procedure to follow when partially renewing components is the same as
described in the section "Welded Components".
The main difference when components are partially, rather than completely
renewed, concerns the preparation of butt or lap joints.
When bodywork components are cut through, atte
© 2019-2026 Copyright www.lrdisc.com
