Land Rover Discovery: Wheel changing
Land Rover Discovery (2009–2016) Owner's Manual / Wheel changing
READ NEXT:
Wheel changing safety
Before raising the vehicle or changing a
wheel, make sure that you read and
comply with the following warnings:
Always find a safe place to stop;
off the highway and away from
traffic.
Do not jac
Tool kit
5 seat vehicles
Lift the loadspace floor to access the
temporary use spare wheel and tool kit.
Temporary use spare wheel locking
ring.
Temporary use spare wheel retaining
bolt.
Tool kit retain
Removing the spare wheel
Remove the temporary spare
wheel prior to jacking the vehicle,
to avoid destabilising the vehicle
when raised.
Wheels are heavy and if handled
incorrectly may cause injury. Use
extreme caution
SEE MORE:
Rear Drive Axle
- Differential - Vehicles without- Active Driveline
Active
on-demand Coupling Module (G1775371)
/ Removal and Installation
REMOVAL
NOTES:
This procedure contains some variation in the illustrations
depending on the vehicle specification, but the essential
information is always correct.
This procedure contains illustrations showing certain components
removed to provide extra clarity.
Raise and support the vehicle
Fuel Rail Pressure
Control Valve (PCV)
The fuel rail Pressure Control Valve (PCV) is located in a threaded port in
the
rearward end of the fuel rail. The PCV regulates the fuel pressure within the
fuel rail and is controlled by the ECM using Pulse Width Modulation (PWM)
outputs to the solenoid valve.
When the solenoid is de-energized
© 2019-2026 Copyright www.lrdisc.com
