Land Rover Discovery: Gearbox
READ NEXT:
Automatic transmission
The gear selection status of the rotary gear
selector and the steering wheel's gear
selector paddles (Commandshift), will be
displayed in the Message centre.
When the engine starts, the rotary gear
Manual gear selection
The gear shift paddles can be configured
to be active in both Drive (D) and Sport
(S) or active in S only, via the vehicle
settings/set-up.
When the gear selector is in the D position
(unless set to b
Stability control
DYNAMIC STABILITY CONTROL
(DSC)
Dynamic Stability Control (DSC)
is unable to compensate for driver
misjudgement. It remains the
driver's responsibility to drive
with due care and attention, in a
SEE MORE:
Crankshaft Rear Seal (G1875871) / Removal and Installation
SPECIAL TOOL(S)
PART(S)
REMOVAL
All vehicles
Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
Raise and support the vehicle.
Vehicles with automatic transmission
Refer to: Flexplate (303-01B Engine - INGENIUM I4 2.0L Diesel,
R
General Installation Instructions
COMPONENT REMOVAL
Whenever possible, clean components and the surrounding area before
removal.
Blank off openings exposed by component removal.
Following disconnection, seal fuel, oil or hydraulic lines immediately
using
suitable blanking plugs or caps.
Seal open ends of exposed oilways using
© 2019-2026 Copyright www.lrdisc.com
