Land Rover Discovery Owners & Service Manuals

Land Rover Discovery: Exterior lights

READ NEXT:

 Lighting control

With the headlamps on, push the control away from the steering wheel to select high beam. The Instrument panel warning lamp will illuminate. Note: Do not use high beam where it may distract ot

 Headlamp courtesy delay

This feature operates whenever the lighting control is in the auto position and the ignition is switched off. The headlamps will remain illuminated for up to 240 seconds. Note: The time delay may be c

 Windscreen wiper detection

If Auto lamps is selected and the windscreen wipers are switched on for 20 seconds or more, the side lamps, tail lamps and headlamps will switch on automatically. When the wipers are switched off, the

SEE MORE:

 Reprogramming a single garage door opener button

To program a remote device to a previously programmed RF transceiver memory button: Press and hold the desired RF transceiver memory button. After approximately 20 seconds, the LED will start to flash slowly. Follow the instructions described in step (2) onwards, as described in PROGRAMMING.

 Cylinder Head Gasket (G1875895) / Installation

INSTALLATION Check cylinder head face for distortion, across the center and from corner to corner. CAUTION: Make sure that the dowels and dowel holes are clean and free from debris and foreign material. NOTE: The cylinder head gasket must be installed over the cylinder head to cylinder block dow

© 2019-2026 Copyright www.lrdisc.com