Land Rover Discovery: Fluid level checks
Land Rover Discovery (2009–2016) Owner's Manual / Fluid level checks
- Fluid filler locations
- Checking the engine oil level
- Topping up the oil
- Topping up the coolant
- Checking the brake/clutch fluid level
- Checking the washer fluid level
READ NEXT:
Fluid filler locations
Brake fluid reservoir cap (right-hand
drive). Remove the right-side under
bonnet cover for access.
Engine oil filler cap (2.0L petrol
engine).
Brake fluid reservoir cap (left-hand
drive).
Checking the engine oil level
Check the engine oil weekly. If any
significant or sudden drop in oil
level is noted, seek qualified
assistance.
Never allow the oil level to fall
below the lower mark or notch on
the dipstick
Topping up the oil
Your vehicle's warranty may be
invalidated if damage is caused by
using oil that does not meet the
required specification.
Failure to use an oil that meets the
required specification could caus
SEE MORE:
Wheel Speed Sensors
Retaining screw
Wheel speed sensor
Bearing seal and magnetic encoder ring
Wheel bearing
Wheel hub
An active wheel speed sensor is installed in each wheel knuckle, and
provides the Anti-lock Brake System (ABS) control module with a rotational
speed signal from each road wheel. The head of ea
Anti-lock Control Anti-lock Brake System Module (G1807249) / Removal and
Installation
REMOVAL
CAUTIONS:
If brake fluid is spilt on the paintwork, the affected area must
be
immediately washed down with cold water.
Make sure that all openings are sealed. Use new blanking caps.
NOTES:
Removal steps in this procedure may contain installation details.
LHD illustration shown, RHD
© 2019-2026 Copyright www.lrdisc.com
