Land Rover Discovery (2009–2016) Service Manual
Land Rover Discovery (2009–2016) Service Manual
Service and Repair manual for fourth generation of Land Rover Discovery, a series of seven-seater family SUVs.
- General Information
- About This Manual
- Diesel Fuel System Health and Safety Precautions
- General Service Information
- Health and Safety Precautions
- How To Use This Manual
- Identification Codes / Description and Operation
- Jacking and Lifting - Jacking
- Jacking and Lifting - Lifting
- Jacking and Lifting - Vehicle Recovery
- Petrol and Petrol-Ethanol Fuel Systems Health and Safety Precautions
- Road Test
- Road- Roller Testing
- Solvents, Sealants and Adhesives
- Standard Workshop Practices
- Supplemental Restraint System Health and Safety Precautions
- Vehicle Inspection
- Body
- Body closures
- Body Repairs and General Information
- Bumpers
- Exterior trim and ornamentation
- Frame and mounting
- Front end body panels
- Glass, Frames and Mechanisms
- Handles, Locks, Latches and Entry Systems
- Interior Trim and Ornamentation
- Mirrors
- Seatbelt and Supplemental Restraint System
- Seating
- Wipers and washers
- Chassis
- Electrical
- Battery and Charging System
- Climate Control System
- Electronic Feature Group
- Information and Entertainment System
- Instrument and Warning Systems
- Lighting
- Powertrain
READ NEXT:
About This Manual
INTRODUCTION
This manual has been written in a format that is designed to meet the needs
of technicians worldwide. The objective is to use common formats and
include similar content in each manual.
T
TAS Graphics
Colors used in the graphic are as follows:
Blue - Indicates the target item, item to be removed/installed or
disassembled/assembled
Green and Brown - Indicates a secondary item that needs to be de
SEE MORE:
Accelerator Pedal (G1350481)
/ Removal and Installation
REMOVAL
NOTES:
Removal steps in this procedure may contain installation details.
LH illustration shown, RH is similar.
Torque: 10 Nm
INSTALLATION
To install, reverse the removal procedure.
Reprogramming a single garage door opener button
To program a remote device to a
previously programmed RF transceiver
memory button:
Press and hold the desired RF
transceiver memory button. After
approximately 20 seconds, the LED
will start to flash slowly.
Follow the instructions described in
step (2) onwards, as described in
PROGRAMMING.
© 2019-2026 Copyright www.lrdisc.com
