Land Rover Discovery: Automatic Transmission Transaxle
Land Rover Discovery (2009–2016) Service Manual / Powertrain / Automatic Transmission Transaxle
- External Controls Transmission Control Switch
- External Controls
- Automatic Transmission Transaxle / Description and operation
- Automatic Transmission Transaxle/ Diagnosis and Testing
- Four-wheel Drive Systems - Vehicles With
- Main Control Valve Body Solenoids (G1948467) / Removal and Installation
- Main Control Valve Body Solenoids (G1948467) / Removal and Installation
- Selector Shaft Seal - Ingenium i4 2.0l Diesel (G1894392) / Removal and Installation
- Torque Converter - Ingenium i4 2.0l Diesel (G1894240) / Removal and Installation
- Torque Converter Seal - Ingenium i4 2.0l Diesel (G1894394) / Removal and Installation
- Transmission - Ingenium i4 2.0l Diesel (G1887785) / Removal
- Transmission - Ingenium i4 2.0l Diesel (G1887786) / Installation
- Transmission Cover (G1780374) / Removal and Installation
- Transmission Fluid Drain and Refill (G1660818) / General Procedures
- Transmission Fluid Level Check (G1660817) / General Procedures
- Transmission Fluid Pan - Ingenium i4 2.0l Diesel (G1894395) / Removal and Installation
- Transmission Oil Supply Pipe (G1707722) / Removal and Installation
- Transmission Transaxle Cooling Description and Operation
Speed Control Switch (G1780347)
/ Removal and InstallationExternal Controls
Transmission Control
Switch
READ NEXT:
External Controls
Transmission Control
Switch
External Controls
Transmission Control
Switch (G1816637)
Removal and Installation
REMOVAL
NOTES:
Some variation in the illustrations may occur, but the essential
information is always correct.
Rem
External Controls
/ Description and Operation
COMPONENT LOCATION
Downshift paddle switch
Upshift paddle switch
Transmission Control Switch (TCS)
OVERVIEW
The external controls comprise a rotary TCS (transmission control switch)
and two ste
SEE MORE:
Exterior Trim and Ornamentation
Rear Spoiler (G1791772)
- Removal
Removal
CAUTIONS:
Make sure to protect the paintwork.
Make sure that all openings are sealed. Use new blanking caps.
Refer to: High Mounted Stoplamp (417-01, Removal and
Installation).
CAUTION:
Do not use tools during this operation, removal of the
component(s) must be carried out by hand.
Child seats
For optimum safety, children
should travel in the rear of the
vehicle at all times; front
passenger seat travel is not
recommended. However, if it is
essential that a child travels in the
front (not permitted in Australia),
set the vehicle's seat fully
rearward and seat the child in an
approved forw
© 2019-2026 Copyright www.lrdisc.com
