Land Rover Discovery: Supplemental Restraint System Health and Safety Precautions
WARNINGS:
- Only qualified technicians are allowed to work on pyrotechnic
components.
- INHALED: Exposure to pyrotechnic residue may cause low blood
pressure, severe headache, irritation of mucous membranes,
fainting, shortness of breath or rapid pulse. Move a victim to fresh
air. Seek immediate medical attention.
- EYE CONTACT: Exposure to unburned pyrotechnic residue may
cause irritation, burning and etching of the eyes. Flush immediately
with plenty of cold running water for at least 15 minutes. Seek
immediate medical attention.
- EYE CONTACT: Exposure to burned pyrotechnic residue may cause
irritation, burning and etching of the eyes. Flush immediately with
diluted boric acid solution. Seek immediate medical attention.
- SKIN CONTACT: Unburned pyrotechnic residue may be rapidly
absorbed through the skin in toxic quantities. Wash immediately
with plenty of soap and water. Seek medical attention.
- SKIN CONTACT: Burned pyrotechnic residue may be rapidly
absorbed through the skin in toxic quantities. Wash with plenty of
water. Do not use soap. Seek medical attention.
- SWALLOWED: Unburned pyrotechnic residue is extremely toxic. If
conscious drink plenty of water then induce vomiting. Seek
immediate medical attention. If unconscious, or in convulsions do
not attempt to induce vomiting or give anything by mouth. Seek
immediate medical attention.
- SWALLOWED: Burned pyrotechnic residue is extremely toxic. Drink
plenty of water and seek immediate medical attention.
- The deployment key must only be accessible to authorized
personnel.
- Make sure that the deployment key remains removed from the
deployment equipment except during deployment.
- If permenantly disabling or enabling the passenger air bag a
new
seat belt for vehicles without or with a passenger air bag must be
installed.
- Undeployed pyrotechnic components must not be deployed in the
vehicle.
- Pyrotechnic components must be deployed following local
regulations.
- Check thoroughly that no loose objects can be spread during the
deployment of pyrotechnic components.
- Pyrotechnic components must be transported following local
regulations.
- Never carry out any electrical measurement on disconnected,
undeployed pyrotechnic components.
- Pyrotechnic components must not be disassembled.
- Pyrotechnic components are not interchangeable between vehicles.
- Always carry a live air bag module away from the body with the
air
bag or trim cover pointing upwards.
- Live air bag modules must be placed in a suitable cage when
removed from the vehicle. The air bag or trim cover must be facing upwards.
- Do not install a rearward facing child safety seat to the
passenger
seat with an activated passenger air bag.
CAUTIONS:
- Pyrotechnic components must not be subjected to temperatures
higher than 110ºC.
- Never install aftermarket accessories to the vehicle on or
adjacent
to the supplemental restraint system module.
- Jaguar Land Rover (JLR) is aware that some customers have
requested that the pedestrian protection airbag cover be painted in
an alternative colour. Please note that Retailers are advised that the
pedestrian protection airbag should not be painted in alternative
colours as this is not an approved condition for the system.
READ NEXT:
NOTE:
For additional information on systems/components that must be
checked, refer to the relevant Specification section in the Workshop
Manual.
Vehicle inspections may be carried out for various reas
SEE MORE:
The Progress control button is
located on the centre console.
Note: The driver's seat belt must be
buckled and all of the doors must be
completely closed to enable the feature.
Press and release the button, to enable
the Progress control system. The button's
LED lamp will illuminate, and a warning
l
The Timed climate remote control has an
approximate range of 100 metres. There
is no need to point the antenna at the
vehicle.
ON button.
OFF button.
LED (operation indicator).
Antenna.
Note: Avoid touching the antenna
when operating the ON or OFF
buttons.
Press and hold the ON button for
ap