Land Rover Discovery: Body closures
Land Rover Discovery (2009–2016) Service Manual / Body / Body closures
- Body Closures Front Door (G1785716)/ Removal and Installation
- Body Closures Fuel Filler Door (G1393670) / Removal and Installation
- Body Closures Liftgate (G1785717) / Removal and Installation
- Body Closures Power Liftgate Switch (G1889733) / Removal and Installation
READ NEXT:
Body Closures Front
Door (G1785716)/ Removal and Installation
REMOVA L
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential
information is always correct.
Disconnect the
Body Closures Fuel
Filler Door (G1393670)
/ Removal
and Installation
REMOVAL
CAUTION:
Make sure to protect the paintwork.
INSTALLATION
Body closures fuel filler door assembly (G1393672)
removal and installation
REMOVAL
WARNING:
Avoid flames, sparks or lighted subs
Body Closures Liftgate (G1785717)
/ Removal and
Installation
REMOVAL
CAUTION:
Make sure to protect the paintwork.
NOTE:
Some variation in the illustrations may occur, but the essential
information is always correct.
Disconnect the battery ground cable.
Refer
SEE MORE:
Electronic Engine Controls
- Ingenium i4 2.0l Diesel
Post Selective
Catalyst Reduction
Nox Sensor (G1942280)
/ Removal and Installation
SPECIAL TOOL(S)
REMOVAL
WARNING:
Observe due care when working near a hot exhaust system.
CAUTIONS:
The post selective catalyst reduction NOx sensor and module are a
single component and cannot be serviced separately. Do not
attempt to disconnect the harness from the module, or damage to
the
Fuel Temperature Sensor
and Fuel Metering
Valve
Fuel metering valve
Fuel temperature sensor
Fuel Temperature Sensor
The fuel temperature sensor is located in a threaded port in the HP fuel
pump.
The sensor is a NTC sensor which is connected to the ECM by two wires.
The ECM fuel temperature sensor circuit consists of an internal voltage
di
© 2019-2025 Copyright www.lrdisc.com
