Land Rover Discovery: Handles, Locks, Latches and
Entry Systems
READ NEXT:
REMOVAL
NOTES:
Removal steps in this procedure may contain installation details.
This procedure is for removal and installation of the door lock
cylinder only. The ignition lock and door lock cyli
REMOVAL
CAUTION:
Protect the surrounding paintwork to avoid damage.
NOTES:
Removal steps in this procedure may contain installation details.
Make sure the door window glass is in the fully closed p
REMOVAL
NOTES:
Removal steps in this procedure may contain installation details.
Make sure the door window glass is in the fully closed position.
Refer to: Rear Door Trim Panel (501-05, Removal an
SEE MORE:
CHECK
Check all trims are located and fitted correctly before performing
this procedure.
NOTE:
The rear quarter panel is a fixed point, all alignment
checks must start from the rear quarter panel.
Check all vehicle gaps and profiles.
Vehicle specific and tolerance checks.
Refer to: Body and F
Installation
Dress the flanges where necessary.
Offer up the new spare wheel well and clamp into position. Check
alignment, if correct, proceed to next step, if not, rectify and
recheck before proceeding.
Drill holes the where the metal inert gas (MIG) plug welds are to be
installed as in