Land Rover Discovery: Acceleration and Speed Control
READ NEXT:
REMOVAL
NOTES:
Removal steps in this procedure may contain installation details.
LH illustration shown, RH is similar.
Torque: 10 Nm
INSTALLATION
To install, reverse the removal procedure.
Speed Control Actuator
(G1347794) Removal and Installation
REMOVAL
Refer to: Accelerator Pedal (310-02 Acceleration Control, Removal
and Installation).
INSTALLATION
To install, reverse the removal pr
SEE MORE:
SPECIAL TOOL(S)
REMOVAL
CAUTIONS:
Do not allow halfshafts to hang unsupported at one end or joint
damage will occur.
Make sure the halfshaft constant velocity (CV) joints do not over
articulate. Failure to follow this instruction may result in damage to
the CV joints.
Nuts and bolts must
Avoid running out of fuel.
If the vehicle does run out of fuel, a
minimum of 4 litres will be required to
restart the engine.
The vehicle should be left with the
ignition on for 5 minutes after refuelling,
before attempting to restart the engine.
The vehicle will need to be driven for a
distance of