Land Rover Discovery: Speed Control
Land Rover Discovery (2009–2016) Service Manual / Powertrain / Acceleration and Speed Control / Speed Control
- Speed Control / Description and operation
- Speed Control Switches
- Standard Speed Control
- Adaptive Speed Control
- Adaptive Speed Control Brake System Functions
- Speed Control Sensor (G1780348) / Removal and Installation
- Speed Control Sensor Adjustment (G1780345) / General Procedures
- Speed Control Speed Control / Diagnosis and Testing
- Speed Control Switch (G1780347) / Removal and Installation
READ NEXT:
Speed Control / Description
and operation
Speed Control Actuator
(G1347794) Removal and Installation
REMOVAL
Refer to: Accelerator Pedal (310-02 Acceleration Control, Removal
and Installation).
INSTALLATION
To install, reverse the removal pr
Speed Control Switches
Vehicles with standard speed control
Vehicles with adaptive speed control
Set speed '+' switch (Engage speed control/increase speed)
Resume 'RES' (Resume previous set speed)
Set speed '-' sw
Standard Speed Control
The speed control system is integrated with the engine management system
and uses fueling intervention to automatically maintain a set vehicle speed.
Once engaged, the system can also be used to acce
SEE MORE:
Crankshaft
Thrust washers (2 off)
Timing chain drive sprocket
Pin - dual mass flywheel (manual transmission) or drive plate (automatic
transmission) location
Dynamic balancer drive gear
Lower main bearings (5 off)
Alignment roll pin - Crankshaft pulley / mass damper location
Crankshaft pulley / mass
Battery Care Requirements
BATTERY CARE REQUIREMENTS
4 . 1 RECEIPT OF A NEW VEHICLE
Within 72 hours of receipt of a new vehicle, a battery condition check must
be carried out in accordance with the battery test process utilizing a JLR
approved tester as outlined in the Equipment section (Section 5) of this
procedure.
NOTES
© 2019-2026 Copyright www.lrdisc.com
