Land Rover Discovery: Mirrors
Land Rover Discovery (2009–2016) Service Manual / Body / Mirrors
- Rear View Mirrors Exterior Mirror (G1785542) / Removal and Installation
- Rear View Mirrors Exterior Mirror Cover (G1785543) / Removal and Installation
- Rear View Mirrors Exterior Mirror Motor (G1796587) / Removal and Installation
- Rear View Mirrors / Description and Operation
- Door Mirrors
- Rear View Mirrors / Diagnosis and Testing
Interior Trim and Ornamentation
Rear Door
Trim Panel (G1785134) / Removal and
InstallationRear View Mirrors
Exterior Mirror (G1785542)
/ Removal and Installation
READ NEXT:
Rear View Mirrors
Exterior Mirror (G1785542)
/ Removal and Installation
REMOVAL
CAUTIONS:
Use a suitable trim tool.
Take extra care not to damage the wiring harnesses.
NOTES:
Removal steps in this procedure may contain installation details.
RH illustration shown, L
Rear View Mirrors
Exterior Mirror
Cover (G1785543) / Removal and Installation
REMOVAL
CAUTION:
Use a suitable trim tool.
NOTES:
Removal steps in this procedure may contain installation details.
LH illustration shown, RH is similar.
Refer to: Exterior Mirror Glass (501-09, R
Rear View Mirrors
Exterior Mirror
Motor (G1796587) / Removal and
Installation
REMOVAL
NOTES:
Removal steps in this procedure may contain installation details.
RH illustration shown, LH is similar.
The ignition must be switched off.
Refer to: Exterior Mirror Cover (501-09 R
SEE MORE:
Front Row Passenger
Seat Cushion
Heater Element -
Vehicles with- power Seats
(G1780412) / Removal and Installation
REMOVAL
WARNINGS:
To avoid accidental deployment and possible personal injury,
the
backup power supply must be depleted before repairing or
replacing any air bag supplemental restraint system (SRS)
components. To deplete the backup power supply energy,
disconnect the battery ground cable and
Exhaust - Ingenium i4 2.0l Diesel Catalytic Converter to Turbocharger Clamp
(G1964846)/ Removal and Installation
REMOVAL
Remove the engine cover.
Refer to: Engine Cover - INGENIUM I4 2.0L Diesel (501-05 Interior
Trim and Ornamentation, Removal and Installation).
Remove the heat shield.
Torque: 10 Nm
Using suitable cutting/grinding equipment remove the clamp weld
at the points illustrated
Remove the
© 2019-2026 Copyright www.lrdisc.com
