Land Rover Discovery: Bumpers
Land Rover Discovery (2009–2016) Service Manual / Body / Bumpers
- Front Armature (G1780370) / Removal and Installation
- Front Bumper Cover (G1780369) / Removal and Installation
- Rear Armature (G1780372) / Removal and Installation
- Rear Bumper Cover (G1780371) / Removal and Installation
Body Closure Noise
Vibration and Harshness
SealingFront Armature (G1780370) / Removal and Installation
READ NEXT:
Front Armature (G1780370) / Removal and Installation
Bumpers specifications
Torque Specifications
REMOVAL
NOTE:
Removal steps in this procedure may contain installation details.
WARNING:
Make sure to support the vehicle with axle stands.
Raise and s
Front Bumper Cover (G1780369)
/ Removal and
Installation
Front bumper cover (G1780369)
- Removal
NOTE:
Removal steps in this procedure may contain installation details.
WARNING:
Make sure to support the vehicle with axle stands.
Raise and support
Rear Armature (G1780372) / Removal and Installation
REMOVAL
NOTE:
Removal steps in this procedure may contain installation details.
All vehicles
WARNING:
Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
Refer to: Rea
SEE MORE:
Engine Emission Control - Ingenium i4 2.0l Diesel Diesel Exhaust Fluid Level
Check and top-up (G1979040) / General Procedures
GENERAL EQUIPMENT
CHECK
Using the Land Rover approved diagnostic equipment, follow the
on-screen instructions and check the diesel exhaust fluid level.
General Equipment: Land Rover diagnostic equipment
ADJUSTMENT
CAUTION:
Extreme cleanliness must be exercised when handling these
components.
Rear Drive Axle- Differential - Vehicles with - Active Driveline
Differential Case (G1781298) - Installation
Installation
All vehicles
Install the Rear Drive Unit (RDU) Electronic Control Module (ECM)
Torque: 10 Nm
Install the RDU wiring harness.
Connect the electrical connectors.
Install the RDU breathers.
Install the RDU bolts.
Install the RDU support bracket.
Torque:
M8 29 Nm
M6 10 Nm
In
© 2019-2024 Copyright www.lrdisc.com
