Land Rover Discovery Owners & Service Manuals

Land Rover Discovery: Wipers and washers

READ NEXT:

 Headlamp Washer Jet (G1780361) / Removal and Installation

REMOVAL AND INSTALLATION REMOVAL NOTES: Removal steps in this procedure may contain installation details. Left shown, right is similar. WARNING: Make sure to support the vehicle with axle stands.

 Rain Sensor (G1780360) / Removal and installation

REMOVAL NOTES: Removal steps in this procedure may contain installation details. Make sure the ignition is OFF at all times during the replacement procedure. Refer to: Interior Rear View Mirror (

 Rear Window Wiper Pivot Arm (G1780367) / Removal and Installation

REMOVAL NOTE: Removal steps in this procedure may contain installation details. NOTE: Make sure that this component is installed to the noted removal position. Torque: 5.4 Nm NOTE: Do not disassem

SEE MORE:

 Rear Disc Brake Brake Caliper (G1785110) - Removal

REMOVAL CAUTION: If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water. NOTE: Removal steps in this procedure may contain installation details. Connect the diagnostic tool and set the electronic park brake (EPB) to the maintenance position. NOTE:

 Fuel Temperature Sensor and Fuel Metering Valve

Fuel metering valve Fuel temperature sensor Fuel Temperature Sensor The fuel temperature sensor is located in a threaded port in the HP fuel pump. The sensor is a NTC sensor which is connected to the ECM by two wires. The ECM fuel temperature sensor circuit consists of an internal voltage di

© 2019-2026 Copyright www.lrdisc.com