Land Rover Discovery Owners & Service Manuals

Land Rover Discovery: Engine

READ NEXT:

 Accessory Drive

 Accessory Drive - Ingenium i4 2.0l Diesel Accessory Drive Belt (G1882049) / Removal and Installation

REMOVAL NOTES: Removal steps in this procedure may contain installation details. Engine shown removed for clarity. Disconnect the battery ground cable. Refer to: Specifications (414-01 Battery, M

 Accessory Drive - Ingenium i4 2.0l Diesel / Diagnosis and Testing

PRINCIPLES OF OPERATION For a detailed description of the Accessory Drive Belt, refer to the relevant Description and Operation section in the workshop manual. REFER to: Accessory Drive (303-05B Acces

SEE MORE:

 Rear Drive Axle - Differential - Vehicles without- Active Driveline Differential Case - Vehicles with- 9HP48 9-speed Automatic Transmission - AWD (G1775374) / Removal and Installation

GENERAL EQUIPMENT REMOVAL NOTES: This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct. This procedure contains illustrations showing certain components removed to provide extra clarity. Raise an

 All Wheel Drive Control Module (AWDCM)

The AWDCM is located at the front right side of the RDU, adjacent to the drive flange. The AWDCM is attached to the RDU casing and secured with screws. Two electrical connectors provide the interface between the AWD valve block and the vehicle systems. The upper connector provides the connections

© 2019-2026 Copyright www.lrdisc.com