Land Rover Discovery: Electronic Engine Controls - Ingenium i4 2.0l Diesel
Land Rover Discovery (2009–2016) Service Manual / Powertrain / Engine / Electronic Engine Controls
- Ingenium i4 2.0l Diesel
- Electronic Engine Controls - Ingenium i4 2.0l Diesel Camshaft Position Sensor (G1875922) / Removal and Installation
- Electronic Engine Controls - Ingenium i4 2.0l Diesel Cylinder Head Temperature Sensor (G1875924)/ Removal and Installation
- Electronic Engine Controls - Ingenium i4 2.0l Diesel Engine Control Module (G1875928) / Removal and Installation
- Electronic Engine Controls - Ingenium i4 2.0l Diesel Exhaust Gas Temperature Sensor (G1875930)/ Removal and Installation
- Electronic Engine Controls - Ingenium i4 2.0l Diesel Oil Pressure and Temperature Sensor (G1909611)/ Removal and Installation
- Electronic Engine Controls - Ingenium i4 2.0l Diesel Post Selective Catalyst Reduction Nox Sensor (G1942280) / Removal and Installation
Accessory Drive - Ingenium
i4 2.0l Diesel / Diagnosis and TestingElectronic Engine Controls
- Ingenium i4 2.0l Diesel
Camshaft Position
Sensor (G1875922)
/ Removal and Installation
READ NEXT:
Electronic Engine Controls
- Ingenium i4 2.0l Diesel
Camshaft Position
Sensor (G1875922)
/ Removal and Installation
REMOVAL
NOTE:
Removal steps in this procedure may contain installation details.
Refer to: Engine Cover - INGENIUM I4 2.0L Diesel (501-05 Interior
Trim and Ornamentation, Removal and Installation).
Electronic Engine Controls
- Ingenium i4 2.0l Diesel
Cylinder Head
Temperature Sensor (G1875924)/ Removal and Installation
PART(S)
REMOVAL
CAUTION:
Be prepared to collect escaping coolant.
NOTES:
Some variation in the illustrations may occur, but the essential
information is always correct.
Some components shown rem
Electronic Engine Controls
- Ingenium i4 2.0l Diesel
Engine Control
Module (G1875928)
/ Removal and Installation
REMOVAL
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential
information is always correct.
All vehicles
Disco
SEE MORE:
Hydraulic Brake Actuation Brake Pedal and Bracket (G2164230) / Removal and
Installation
REMOVAL
NOTES:
This procedure contains some variation in the illustrations
depending on the vehicle specification, but the essential
information is always correct.
This procedure contains illustrations showing certain components
removed to provide extra clarity.
Right brake pedal and bracket
Steering Column Diagnosis and
Testing - Pinpoint tests
Pinpoint tests
NOTE:
The steering wheel heater will not operate if the engine is not
running.
NOTES:
An infra-red thermometer is used during this test.
The steering wheel temperature should have increased by
approximately 10ºC after 5 minutes.
Do not measure the steering wheel temperature at t
© 2019-2026 Copyright www.lrdisc.com
