Land Rover Discovery: Fuel Charging and Controls - Ingenium i4 2.0l Diesel Fuel Pump (G1875960)
Land Rover Discovery (2009–2016) Service Manual / Powertrain / Engine / Fuel Charging and Controls
- Ingenium i4 2.0l Diesel
Fuel Pump (G1875960)
- Fuel Charging and Controls - Ingenium i4 2.0l Diesel Fuel Pump (G1875960) / Removal
- Fuel Charging and Controls - Ingenium i4 2.0l Diesel Fuel Pump (G1875960) / Installation
Fuel Charging and Controls
- Ingenium i4 2.0l Diesel
Fuel Injectors (G1875958)
/ Removal and InstallationFuel Charging and Controls
- Ingenium i4 2.0l Diesel
Fuel Pump (G1875960)
/ Removal
READ NEXT:
Fuel Charging and Controls
- Ingenium i4 2.0l Diesel
Fuel Pump (G1875960)
/ Removal
SPECIAL TOOL(S)
REMOVAL
NOTE:
Some variation in the illustrations may occur, but the essential
information is always correct.
WARNING:
Make sure to support the vehicle with axle stands.
Raise and su
Fuel Charging and Controls
- Ingenium i4 2.0l Diesel
Fuel Pump (G1875960)
/ Installation
Remove the component.
Special Tool(s): JLR-303-1627
NOTE:
Lubricate the seal with clean engine oil.
CAUTION:
Extreme cleanliness must be exercised when handling this
component.
CAUTION:
Make sur
SEE MORE:
Hydraulic Control Unit (HCU)
Anti-lock Brake System (ABS) control module
Secondary circuit port
Left front caliper port
Right front caliper port
Primary circuit port
Left rear caliper port
Right rear caliper port
Hydraulic Control Unit (HCU)
The Hydraulic Control Unit (HCU) is located on the rear left side of the
en
Engine System - General
Information Leakage
Test Using
Smoke Test
Equipment (G1445299)
/ General Procedures
CAUTION:
The compressed air line supply pressure must be between 3.5 and 12
bar (50 and 175 psi) for the smoke test equipment to function
correctly. Do not exceed this pressure. Failure to follow this
instruction may result in damage to the smoke test equipment.
NOTES:
The vehicle battery must be
© 2019-2025 Copyright www.lrdisc.com
