Land Rover Discovery: Cylinder Head Gasket (G1875895)
READ NEXT:
PART(S)
REMOVAL
NOTES:
Some variation in the illustrations may occur, but the essential
information is always correct.
Some components shown removed for clarity.
WARNING:
Make sure to support t
INSTALLATION
Check cylinder head face for distortion, across the center and from
corner to corner.
CAUTION:
Make sure that the dowels and dowel holes are clean and
free from debris and foreign mater
SEE MORE:
REMOVAL
CAUTION:
LH illustration shown, RH is similar.
NOTES:
Removal steps in this procedure may contain installation details.
The ignition must be switched off.
WARNING:
Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
Refer to: Wheel and Tire (204-04, Removal
Installation
Dress the flanges where necessary.
Offer up the new back panel inner panel and clamp into position.
Check alignment, if correct, proceed to next step, if not, rectify and
recheck before proceeding.
Drill holes where the metal inert gas (MIG) plug welds are to be
installed as