Land Rover Discovery Owners & Service Manuals

Land Rover Discovery: Engine Cooling - Ingenium i4 2.0l Diesel Cooling System Draining, Filling and Bleeding (G1879552) / General Procedures

Land Rover Discovery (2009–2016) Service Manual / Powertrain / Engine / Engine Cooling - Ingenium i4 2.0l Diesel Cooling System Draining, Filling and Bleeding (G1879552) / General Procedures

next pageEngine Cooling - Ingenium i4 2.0l Diesel Cooling System Concentration Check (G2154751) / General ProceduresEngine Cooling - Ingenium i4 2.0l Diesel Cooling System Drainingnext page

READ NEXT:

 Engine Cooling - Ingenium i4 2.0l Diesel Cooling System Draining

Draining CAUTIONS: The engine cooling system must be maintained with the correct concentration and type of anti-freeze solution to prevent corrosion and frost damage. Failure to follow this instru

 Engine Cooling - Ingenium i4 2.0l Diesel Cooling System  Filling

Lower the vehicle. Refer to: Engine Cover - INGENIUM I4 2.0L Diesel (501-05 Interior Trim and Ornamentation, Removal and Installation). Remove the bleed screw. Remove the bleed screw. Set the

 Engine Cooling - Ingenium i4 2.0l Diesel Cooling System Partial Draining and Vacuum Filling (G1809493) / General Procedures

SPECIAL TOOL(S) DRAINING WARNING: Since injury such as scalding could be caused by escaping steam or coolant, do not remove the filler cap from the coolant expansion tank while the system is hot.

SEE MORE:

 Lubricants and Greases

Avoid all prolonged and repeated contact with mineral oils. All lubricants and greases may be irritating to the eyes and skin. USED ENGINE OIL Prolonged and repeated contact with engine oil will result in the removal of natural fats from the skin, leading to dryness, irritation and dermatitis. In ad

 Galvanic Corrosion

Galvanic corrosion is the cross-contamination of dissimilar metals, in this case aluminium and steel. Avoidance of galvanic corrosion is an important issue to be considered in the repair of aluminium bodied vehicles. Precautions to prevent the contamination of exposed bare aluminium surfaces should

© 2019-2026 Copyright www.lrdisc.com