Land Rover Discovery: Accessory Drive
- Accessory Drive - Ingenium i4 2.0l Diesel Accessory Drive Belt (G1882049) / Removal and Installation
- Accessory Drive - Ingenium i4 2.0l Diesel / Diagnosis and Testing
EngineAccessory Drive - Ingenium
i4 2.0l Diesel Accessory
Drive Belt (G1882049)
/ Removal and Installation
READ NEXT:
Accessory Drive - Ingenium
i4 2.0l Diesel Accessory
Drive Belt (G1882049)
/ Removal and Installation
REMOVAL
NOTES:
Removal steps in this procedure may contain installation details.
Engine shown removed for clarity.
Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, M
Accessory Drive - Ingenium
i4 2.0l Diesel / Diagnosis and Testing
PRINCIPLES OF OPERATION
For a detailed description of the Accessory Drive Belt, refer to the relevant
Description and Operation section in the workshop manual. REFER to:
Accessory Drive (303-05B Acces
SEE MORE:
Dynamic Stability Control (DSC) Switch
DESCRIPTION
The Dynamic Stability Control (DSC) switch is a non-latching switch installed
in the floor console, forward of the selector lever (for manual transmission
vehicles) or Transmission Control Switch (for automatic transmission
vehicles). Pressing the DSC switch connects an ignition power
Vehicle Specific Information and
Tolerance Checks
Rear Door
Alignment
CHECK
Check all trims are located and fitted correctly before performing
this procedure.
NOTE:
The rear quarter panel is a fixed point, all alignment
checks must start from the rear quarter panel.
Check all vehicle gaps and profiles.
Vehicle specific and tolerance checks.
Refer to: Body and Frame (
© 2019-2026 Copyright www.lrdisc.com
