Land Rover Discovery: Engine - Ingenium i4 2.0l Diesel Engine and Ancillaries
Land Rover Discovery (2009–2016) Service Manual / Powertrain / Engine / Engine - Ingenium i4 2.0l Diesel Engine and Ancillaries
Engine - Ingenium i4 2.0l Diesel Engine (G1880415) / InstallationEngine and Ancillaries (G1977457) Removal
READ NEXT:
Engine and Ancillaries (G1977457) Removal
Removal
SPECIAL TOOL(S)
GENERAL EQUIPMENT
Engine hoist (1 tonne minimum capacity)
PART(S)
NOTES:
In this procedure the EU6 Exhaust Gas Recirculation (EGR) assembly
is shown. EU5, EU4 and NAS
Engine and Ancillaries (G1977459) / Installation
INSTALLATION
SPECIAL TOOL(S)
GENERAL EQUIPMENT
Engine hoist (1 tonne minimum capacity)
PART(S)
NOTES:
In this procedure the EU6 Exhaust Gas Recirculation (EGR) assembly
is shown. EU5, EU4 a
Engine Front Cover (G1875898) / Removal and Installation
REMOVAL
NOTES:
Some variation in the illustrations may occur, but the essential
information is always correct.
Removal steps in this procedure may contain installation details.
WARNING:
Make sure
SEE MORE:
Rear Drive Halfshafts
Rear Left
Halfshaft (G1791654) - Removal
SPECIAL TOOL(S)
REMOVAL
CAUTIONS:
Do not allow halfshafts to hang unsupported at one end or joint
damage will occur.
Make sure the halfshaft constant velocity (CV) joints do not over
articulate. Failure to follow this instruction may result in damage to
the CV joints.
Nuts and bolts must
Opening the bonnet
Pull the bonnet release lever, located
in the left-side front footwell.
Lift the bonnet safety catch, located
below the centre point of the bonnet,
then raise the bonnet.
CLOSING THE BONNET
Do not drive with the bonnet
retained by the safety catch
alone.
Lower the bonnet until the safety
© 2019-2026 Copyright www.lrdisc.com
