Land Rover Discovery: Engine - Ingenium i4 2.0l Diesel
Land Rover Discovery (2009–2016) Service Manual / Powertrain / Engine / Engine - Ingenium i4 2.0l Diesel
- Camshafts (G1875875) / Removal and Installation
- Crankshaft Pulley (G1875869) / Removal and Installation
- Crankshaft Rear Seal (G1875871) / Removal and Installation
Electronic Engine Controls
- Ingenium i4 2.0l Diesel
/ Diagnosis and TestingCamshafts (G1875875) / Removal
and Installation
READ NEXT:
Camshafts (G1875875) / Removal
and Installation
SPECIAL TOOL(S)
PART(S)
REMOVAL
NOTE:
Some variation in the illustrations may occur, but the essential
information is always correct.
Some components shown removed for clarity.
Removal steps
Crankshaft Pulley (G1875869)
/ Removal and Installation
SPECIAL TOOL(S)
PART(S)
REMOVAL
NOTE:
Removal steps in this procedure may contain installation details.
WARNING:
Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
Di
Crankshaft Rear Seal (G1875871) / Removal and Installation
SPECIAL TOOL(S)
PART(S)
REMOVAL
All vehicles
Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
Raise and support the vehicle.
V
SEE MORE:
Engine Cooling - Ingenium i4 2.0l Diesel Cooling System Concentration Check
(G2154751) / General Procedures
GENERAL EQUIPMENT
Refractometer / Hydrometer
CHECK
CAUTIONS:
The engine cooling system must be maintained with the correct
concentration and type of anti-freeze solution to prevent corrosion
and frost damage.
Engine coolant will damage the paint finished surfaces. If spilt,
immediately remove
Solvents, Sealants and Adhesives
SOLVENTS
WARNING:
Always handle all solvents, sealers and adhesives with extreme care.
Some contain chemicals or give off fumes which can be dangerous to
health. Always follow the manufacturers instructions. If in doubt about
any substance, particularly a solvent, DO NOT use it.
CAUTION:
If in doub
© 2019-2026 Copyright www.lrdisc.com
