Land Rover Discovery: Lighting
- Autolamps
- Fog Lamps
- Headlamp Leveling
- Headlamps
- Parking, Rear and License Plate Lamps
- Reversing Lamps
- Stoplamps
- Trailer Lamps
- Turn Signal and Hazard Lamps
- Front Turn Signal Lamp Bulb (G1785540) Removal and Installation
READ NEXT:
Autolamps
PRINCIPLES OF OPERATION
For a detailed description of the Autolamps, refer to the relevant
Description and Operation section in the workshop manual. REFER to:
Exterior Lighting (417-01 Exterior Lighti
Daytime Running Lamps / Description and Operation
OVERVIEW
The Daytime Running Lamps (DRL) and side lamps are incorporated into the
headlamp assemblies.
For additional information, refer to: Exterior Lighting (417-01, Description
and Operation).
On
Daytime Running Lamps / Diagnosis and Testing
PRINCIPLES OF OPERATION
For a detailed description of the Daytime Running Lamps, refer to the
relevant Description and Operation section in the workshop manual. REFER
to: Daytime Running Lamps (417-04
SEE MORE:
Front end Sheet Metal
Repairs Fender
Apron Panel
Front Reinforcement (G1775679) - Installation
Installation
Dress flanges where necessary.
Using the old fender apron panel front reinforcement as a guide,
drill holes in the new fender apron panel front reinforcement where
the metal inert gas (MIG) plug welds are to be installed as
indicated.
Drill holes where the MIG plug welds
Rear end Sheet Metal
Repairs Rear
Floor Side
Extension (G1770934)
- Installation
Installation
Dress the flanges where necessary.
Offer up the new rear floor side extension and clamp into position.
Check alignment if correct, proceed to next step, if not, rectify and
recheck before proceeding.
NOTE:
Make sure the holes are drilled through the side member and
the rear floor
© 2019-2026 Copyright www.lrdisc.com
