Land Rover Discovery: Parking Aid
- Parking Aid Front Inner Parking Aid Sensor (G1780349) / Removal and Installation
- Parking Aid Front Parking Aid Camera (G1780351) / Removal and Installation
- Parking Aid Parking Aid Camera Module (G1780353) / Removal and Installation
- Parking Aid Parking Aid Module (G1780354) / Removal and Installation
- Parking Aid Rear Outer Parking Aid Sensor (G1780356) / Removal and Installation
- Parking Aid Description and Operation
- Parking Aid Control Module (PACM)
- Proximity Cameras
- Detection Calculation
- Perpendicular / Parallel parking
- Parking Exit
- Proximity Camera System - Operation
Instrument Cluster / Diagnosis and TestingParking Aid Front Inner Parking Aid Sensor (G1780349) / Removal and
Installation
READ NEXT:
Parking Aid Front Inner Parking Aid Sensor (G1780349) / Removal and
Installation
REMOVAL
NOTES:
LH illustration shown, RH is similar.
Removal steps in this procedure may contain installation details.
The ignition must be switched off.
WARNING:
Make sure to support the vehicle
Parking Aid Front Parking Aid Camera (G1780351) / Removal and Installation
REMOVA L
NOTES:
Removal steps in this procedure may contain installation details.
The ignition must be switched off.
WARNING:
Make sure to support the vehicle with axle stands.
Raise and support t
Parking Aid Parking Aid Camera Module (G1780353) / Removal and Installation
REMOVAL
NOTES:
Removal steps in this procedure may contain installation details.
The ignition must be switched off.
Refer to: Front Row Seat - Vehicles With: Power Seats (501-10
Seating, Removal a
SEE MORE:
Steering wheel
ADJUSTING THE STEERING WHEEL
Never adjust the steering column
while the vehicle is in motion.
Move the lever fully down to unlock
the column. When the steering has
been adjusted to the desired position,
move the lever fully up to re-lock the
column.
The steering column can be adjusted,
up,
Rear end Sheet Metal
Repairs Back
Panel Outer
(G1770946)
- Installation
INSTALLATION
Dress the flanges where necessary.
Offer up the new back panel outer panel and clamp into position.
Check alignment, if correct, proceed to next step, if not, rectify and
recheck before proceeding.
Drill holes where the MIG plug welds are to be installed as
indicated.
Remove
© 2019-2026 Copyright www.lrdisc.com
