Land Rover Discovery: Rear Disc Brake Brake Caliper (G1785110)
Land Rover Discovery (2009–2016) Service Manual / Chassis / Chassis-Brake-System / Rear Disc Brake Brake Caliper (G1785110)
- Rear Disc Brake Brake Caliper (G1785110) - Removal
- Rear Disc Brake Brake Caliper (G1785110) - Installation
Power Bbrake Actuation / Description and OperationRear Disc Brake Brake Caliper (G1785110) - Removal
READ NEXT:
Rear Disc Brake Brake Caliper (G1785110) - Removal
REMOVAL
CAUTION:
If brake fluid is spilt on the paintwork, the affected area must be
immediately washed down with cold water.
NOTE:
Removal steps in this procedure may contain installation details.
Co
Rear Disc Brake Brake Caliper (G1785110) - Installation
CAUTION:
A new O-ring seal is to be installed.
NOTE:
This step is only required if previously removed.
Torque: 11 Nm
Torque: 28 Nm
NOTE:
Remove and discard all blanking caps.
Torque:
Line union
Rear Disc Brake Brake Caliper Anchor Plate (G1785111) / Removal and
Installation
PART(S)
REMOVAL
NOTE:
Removal steps in this procedure may contain installation details.
Connect the diagnostic tool and set the electronic park brake (EPB)
to the maintenance position
NOTE:
This
SEE MORE:
Fuel Charging and Controls
- Turbocharger - Ingenium i4
2.0l Diesel Turbocharger
Oil Return
Hose (G1875965)
/ Removal and Installation
REMOVAL
NOTES:
Some variation in the illustrations may occur, but the essential
information is always correct.
Some components shown removed for clarity.
WARNING:
Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
Refer to: Specifications (414-01 Battery, Mounting
Rear Drive Halfshafts
Outer Constant
Velocity Joint
Boot (G1791657) / Installation
Installation
CAUTION:
Extreme cleanliness must be exercised when handling these
components.
Clean and inspect the components for deterioration.
CAUTION:
Make sure that a new outer joint boot is to be installed.
Renew Part: Outer constant velocity joint boot kit.
Pack the outer CV joint with the
© 2019-2026 Copyright www.lrdisc.com
