Land Rover Discovery: Rear Suspension Wheel
Knuckle (G1775239)
READ NEXT:
SPECIAL TOOL(S)
PART(S)
REMOVAL
CAUTIONS:
Nuts and bolts must be tightened with the weight of the vehicle on
the suspension.
Do not allow halfshafts to hang unsupported at one end or joint
dam
INSTALLATION
CAUTION:
Install a new and bolt.
NOTE:
All wheel drive transmission illustrations shown, front wheel
drive transmission is similar.
Renew Part: Wheel knuckle nut and bolt.
Torque:
Stage
COMPONENT LOCATION
Shock absorber
Spring
Stabilizer bar
Wheel knuckle
Tie arm
Lower control arm
Subframe
Stabilizer bar link
OVERVIEW
An advanced multi-link rear suspension is introduced pr
SEE MORE:
Installation
Dress the flanges where necessary.
Offer up the new spare wheel well and clamp into position. Check
alignment, if correct, proceed to next step, if not, rectify and
recheck before proceeding.
Drill holes the where the metal inert gas (MIG) plug welds are to be
installed as in
GENERAL
WARNING:
The following instructions must be adhered to before raising the
vehicle off the ground:
Position vehicle on a solid, level surface.
Apply the parking brake.
Select 'P' - PARK on automatic transmission selector.
Select 'N' - Neutral on manual transmission.
WARNING:
If the driv