Land Rover Discovery: Seatbelt System / Description and Operation
Land Rover Discovery (2009–2016) Service Manual / Body / Seatbelt and Supplemental Restraint
System / Seatbelt System / Description and Operation
- Seatbelt System - Component Location
- Seatbelt System - Overview
- Seatbelt System - Operation
- Seatbelt System - Input/ Output Diagram
Rear Safety Belt
Retractor (G1809589) / Removal and
InstallationSeatbelt System - Component Location
READ NEXT:
Seatbelt System - Component Location
Component Location - Sheet 1 of 3 - 5 Seat Vehicles
Front right seatbelt retractor and pretensioner
Front right seatbelt
Rear right seatbelt
Rear right seatbelt retractor
Rear seatbelt buckles
Seatbelt System - Overview
A 3 point seatbelt is installed in all seating positions. Each seatbelt has
emergency locking retractor functionality.
The emergency locking retractor function incorporates a lift shaft locking
syste
Seatbelt System - Operation
FRONT BELT MINDER FUNCTION
The belt minder function provides warnings to the driver if the appropriate
front seatbelts are not fastened when driving. The belt minder function is
controlled by the IC
SEE MORE:
Exhaust - Ingenium i4 2.0l Diesel Catalytic Converter to Turbocharger Clamp
(G1964846)/ Removal and Installation
REMOVAL
Remove the engine cover.
Refer to: Engine Cover - INGENIUM I4 2.0L Diesel (501-05 Interior
Trim and Ornamentation, Removal and Installation).
Remove the heat shield.
Torque: 10 Nm
Using suitable cutting/grinding equipment remove the clamp weld
at the points illustrated
Remove the
Rear Drive Halfshafts
Outer Constant
Velocity Joint
Boot (G1791657) Removal
Removal
CAUTION:
The outer CV joint and the rear halfshaft are serviced together and
must not be separated. The inner joint and boot have to be removed
to allow the outer joint boot to be replaced.
NOTE:
Some variation in the illustrations may occur, but the essential
information is always correct.
© 2019-2025 Copyright www.lrdisc.com
