Land Rover Discovery: Body Repairs - Corrosion Protection
Land Rover Discovery (2009–2016) Service Manual / Body / Body Repairs and General
Information / Body Repairs - Corrosion
Protection
READ NEXT:
Galvanic Corrosion
Galvanic corrosion is the cross-contamination of dissimilar metals, in this
case aluminium and steel. Avoidance of galvanic corrosion is an important
issue to be considered in the repair of aluminium
Partial Renewal
The procedure to follow when partially renewing components is the same as
described in the section "Welded Components".
The main difference when components are partially, rather than completely
renew
Approved Service Materials for
Repair
If any of these items are not available check with the supplier/manufacturer
of these products for a superseded equivalent.
APPROVED SERVICE MATERIAL SUPPLIER - CONTACT DETAILS
3M
3M Uni
SEE MORE:
Wiper Pivot Arm (G1780362) / Removal and Installation
REMOVAL
NOTES:
Removal steps in this procedure may contain installation details.
LHD illustration shown, RHD is similar.
CAUTION:
Note the installed position of the component prior to
removal.
Torque: 25 Nm
NOTE:
Do not disassemble further if the component is removed for
access only.
INSTA
Seat Heater Mat
Faults -Diagnostic Guidance
Seat Heater Sensor Faults - Each seat has two heating elements: one in
the base (seat cushion), and one in the back (squab). There is only one
sensor, which is located in the base. This sensor controls both heating
elements. If there is a fault with the sensor signal, neither element will
oper
© 2019-2026 Copyright www.lrdisc.com
