Land Rover Discovery: Front Suspension Front Shock Absorber (G1779642)
Land Rover Discovery (2009–2016) Service Manual / Chassis / Chassis-Suspension / Front Suspension Front
Shock Absorber (G1779642)
- Front Suspension Front Shock Absorber (G1779642) - Removal
- Front Suspension Front Shock Absorber (G1779642) - Installation
READ NEXT:
Front Suspension Front
Shock Absorber (G1779642) - Removal
GENERAL EQUIPMENT
PART(S)
REMOVAL
WARNINGS:
Make sure the spring compressor Safe Working Load (SWL) meets
or exceeds the spring rating quoted in the Specifcations section.
Always follow the spr
Front Suspension Front
Shock Absorber (G1779642) - Installation
Installation
Make sure the correct vehicle suspension components are installed.
Refer to: Specifications (204-00 Suspension System - General
Information, Specifications).
Inspect the componen
Front Suspension Front
Stabilizer Bar - AWD (G2028382)
/ Removal and
Installation
PART(S)
REMOVAL
CAUTION:
The suspension arm nuts and bolts must be tightened with the
suspension arms in the normal ride position. Failure to follow this
instruction may result in premature failure
SEE MORE:
Engine Emission Control - Ingenium i4 2.0l Diesel Diesel Exhaust Fluid Level
Check and top-up (G1979040) / General Procedures
GENERAL EQUIPMENT
CHECK
Using the Land Rover approved diagnostic equipment, follow the
on-screen instructions and check the diesel exhaust fluid level.
General Equipment: Land Rover diagnostic equipment
ADJUSTMENT
CAUTION:
Extreme cleanliness must be exercised when handling these
components.
Electronic Engine Controls
- Ingenium i4 2.0l Diesel
Post Selective
Catalyst Reduction
Nox Sensor (G1942280)
/ Removal and Installation
SPECIAL TOOL(S)
REMOVAL
WARNING:
Observe due care when working near a hot exhaust system.
CAUTIONS:
The post selective catalyst reduction NOx sensor and module are a
single component and cannot be serviced separately. Do not
attempt to disconnect the harness from the module, or damage to
the
© 2019-2026 Copyright www.lrdisc.com
