Land Rover Discovery: Incontrol secure
In the event of your vehicle being moved illegally, the Stolen Vehicle Monitoring Centre immediately alerts you and liaises with the police to pinpoint the exact location of your vehicle. Alternatively, use the Land Rover InControl Remote app, or the phone number on the InControl website, to contact the Stolen Vehicle Monitoring Centre.
InControl Secure uses tracking technology which activates automatically in the event of:
- Attempted tampering with the vehicle.
- The vehicle being moved with the ignition switched off (e.g., towed away).
- The vehicle alarm sounding for more than 30 seconds.
- Attempted GSM (Global System for Mobile communication) jamming.
- Disconnecting the GSM antenna.
- Disconnecting the GNSS (Global Navigation Satellite System) antenna.
- Disconnecting the vehicle's battery.
When the vehicle is being transported, serviced or repaired, Transport Mode or Service Mode must be enabled. This can be done by using theLand Rover InControl Remote app, or via the InControl website. This prevents automatic theft alerts being raised while the vehicle is being serviced.
Note: When set, Transport Mode or Service Mode should be updated every 10 hours, or more frequently, if required.
READ NEXT:
Incontrol WI-FI
InControl Wi-Fi allows in-car connection
to the internet using a 3G connection. It
utilises the roof mounted antenna,
increasing the reliability of continuous 3G
connection while on the move. Better d
The navigation system
Navigation instruction is by map and turn
information displayed on the Touch screen
and can be complemented by voice
guidance, if required. The system uses
signals from Global Positioning System
(GPS)
SEE MORE:
General Information Battery
Care Requirements
INTRODUCTION
This document defines the requirements for care and maintenance of
batteries, and the standard of battery care at retailers for new vehicles.
This applies to all types of 12 Volt Lead Acid Batteries used in Jaguar and
Land Rover vehicles whether they are conventional flooded technol
Resuming the speed and follow mode
RES should only be used if the
driver is aware of the set speed and
intends to return to it.
By pressing the RES button after ACC has
been cancelled (e.g. after braking), ACC
will become active again provided that
the set speed memory has not been
erased. The original set speed will be
resumed (unle
