Land Rover Discovery: Ride and Handling Optimization Ride and Handling Optimization Switch (G1779911)/ Removal and Installation
Land Rover Discovery (2009–2016) Service Manual / Chassis / Chassis-Suspension / Ride and Handling Optimization
Ride and Handling
Optimization Switch
(G1779911)/ Removal and Installation
REMOVAL
NOTES:
- Some variation in the illustrations may occur, but the essential information is always correct.
- Some components shown removed for clarity.
- Removal steps in this procedure may contain installation details.
Refer to: Floor Console Upper Section (501-12 Instrument Panel and Console, Removal and Installation).
NOTE:
Repeat the step for the other side.
.jpg)
NOTE:
Repeat the step for the other side.
.jpg)
NOTE:
Repeat the step for the other side.
.jpg)
NOTE:
Repeat the step for the other side.
.jpg)
.jpg)
.jpg)
.jpg)
NOTE:
Repeat the step for the other side.
.jpg)
.jpg)
.jpg)
.jpg)
INSTALLATION
To install, reverse the removal procedure.
READ NEXT:
Ride and Handling Optimization
/ Description and Operation
TERRAIN RESPONSE
Power Steering Control Module (PSCM)
Engine control Module (ECM)
ABS module
Terrain Response Switchpack
Integrated Suspension Control Module (ISCM)
Transmission control module
OVERV
Ride and Handling Optimization
/ Diagnosis and Testing
PRINCIPLES OF OPERATION
For a detailed description of the Ride and Handling Optimization, refer to
the relevant Description and Operation section in the workshop manual.
REFER to: Ride and Handling O
Vehicle Dynamic Suspension
Front Suspension
Height Sensor (G1426750)
/ Removal
and Installation
REMOVAL
CAUTION:
LH illustration shown, RH is similar.
NOTES:
Removal steps in this procedure may contain installation details.
Vehicles without dynamic suspension, but with automatic headlamp
lev
SEE MORE:
Airbags
Front passenger's airbag.
Curtain airbags.
Side airbags.
Curtain airbags (7 seat vehicles only).
Driver's airbag.
Knee-bolster airbag.
Note: The general location of airbags
fitted to the vehicle are marked by the
word AIRBAG.
Always contact your Retailer/Authorised
Repairer if:
An airbag
Side Panel Sheet
Metal Repairs 'B'
Pillar Outer
Panel (G1770904) - Installation
Installation
Dress the flanges where necessary
Using the old B-pillar outer panel for reference measure, mark and
cut the new B-pillar outer panel where the Metal Inert Gas (MIG)
welded butt joints are to be made as indicated.
Offer up the new B-pillar outer panel and clamp into position.
© 2019-2026 Copyright www.lrdisc.com
