Land Rover Discovery: Vehicle Dynamic Suspension
Land Rover Discovery (2009–2016) Service Manual / Chassis / Chassis-Suspension / Vehicle Dynamic Suspension
Vehicle Dynamic Suspension
Rear Suspension
Height Sensor (G1779910)
/ Removal
and InstallationVehicle Dynamic Suspension - Component location
READ NEXT:
Vehicle Dynamic Suspension - Component location
Rear right adaptive shock absorber
Rear right spring
Rear right height sensor
Rear left spring
Rear left adaptive shock absorber
Rear left height sensor
Suspension Control Module (SUM)
Fron
Vehicle Dynamic Suspension
- Operation
The SUM uses a combination of information from other system modules and
data from the height sensors to measure the vehicle and suspension states
and driver inputs. Using this information, the SUM app
SEE MORE:
Active Driveline System
Active Driveline Hydraulic Circuit Diagram
Reservoir
Suction filter
Electric actuator
RDU pump
Pressure Control Valve (PCV) P1
PCV P2
PCV P3
PCV P4
PTU synchroniser piston
Bleed orifice
Left RDU clutch piston
Right RDU clutch piston
The Active Driveline system is controlled by the AW
Rear Drive Axle-
Differential - Vehicles without- Active Driveline
Drive
Pinion Flange -
Vehicles with- 9HP48 9-speed Automatic
Transmission - AWD
(G1775379) / Installation
Installation
WARNING:
Make sure that a new nut is installed.
Special Tool(s): 205-053
Torque: 150 Nm
CAUTION:
The component must be aligned with the installation
markings.
Make sure new Driveshaft bolts are installed.
Torque: 40 Nm
Torque: 25 Nm
Check and top-up the active on-demand couplin
© 2019-2026 Copyright www.lrdisc.com
