Land Rover Discovery: Front end Sheet Metal Repairs Fender Apron Panel Front Section (G1775681)
Land Rover Discovery (2009–2016) Service Manual / Body / Body Repairs and General
Information / Front end Sheet Metal
Repairs Fender
Apron Panel
Front Section (G1775681)
- Front end Sheet Metal Repairs Fender Apron Panel Front Section (G1775681) - Removal
- Front end Sheet Metal Repairs Fender Apron Panel Front Section (G1775681) - Installation
Front end Sheet Metal
Repairs Fender
Apron Panel
Reinforcement (G1770870)
/ Removal and InstallationFront end Sheet Metal
Repairs Fender
Apron Panel
Front Section (G1775681)
- Removal
READ NEXT:
Front end Sheet Metal
Repairs Fender
Apron Panel
Front Section (G1775681)
- Removal
REMOVAL
NOTE:
The fender apron panel front section is installed in conjunction with:
Front bumper cover
Hood
Hood hinge
Hood latch panel
Front fender
Fender splash shield
The fender apron
Front end Sheet Metal
Repairs Fender
Apron Panel
Front Section (G1775681)
- Installation
Installation
Dress flanges where necessary.
Remove the spot welds from the new fender apron panel as
indicated.
Carefully separate the fender apron panel from the reinforcement.
Mark, me
SEE MORE:
Parking Aid Front Inner Parking Aid Sensor (G1780349) / Removal and
Installation
REMOVAL
NOTES:
LH illustration shown, RH is similar.
Removal steps in this procedure may contain installation details.
The ignition must be switched off.
WARNING:
Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
Refer to: Front Bumper Cover (501-19 Bumpers, Remo
Seat Smoothing
CHECK
WARNINGS:
Make sure that the steamer is in the OFF position before
connecting or disconnecting from the electrical outlet.
Do not use another high wattage device on the same electrical
circuit.
If the use of an extension cord is absolutely necessary, the
cord
must be rated at a minimu
© 2019-2026 Copyright www.lrdisc.com
