Land Rover Discovery: Front Suspension Shock Absorber and Spring Assembly (G1779643)
Land Rover Discovery (2009–2016) Service Manual / Chassis / Chassis-Suspension / Front Suspension Shock
Absorber and Spring
Assembly (G1779643)
- Front Suspension Shock Absorber and Spring Assembly (G1779643) - Removal
- Front Suspension Shock Absorber and Spring Assembly (G1779643) - Installation
Front Suspension Lower ARM (G2028296)
/ Removal and InstallationFront Suspension Shock
Absorber and Spring
Assembly (G1779643) - Removal
READ NEXT:
Front Suspension Shock
Absorber and Spring
Assembly (G1779643) - Removal
SPECIAL TOOL(S)
GENERAL EQUIPMENT
PART(S)
Removal
CAUTION:
Nuts and bolts must be tightened with the weight of the vehicle on
the suspension.
NOTE:
Some variation in the illustrations ma
Front Suspension Shock
Absorber and Spring
Assembly (G1779643) -
Installation
Installation
All vehicles
NOTE:
Make sure that the component is installed to the noted
removal position.
Torque: 32 Nm
NOTE:
Make sure that this component is installed to the noted
removal positio
Front Suspension Spring (G1779644)
/ Removal and Installation
REMOVAL
WARNINGS:
Make sure the spring compressor Safe Working Load (SWL) meets
or exceeds the spring rating quoted in the Specifcations section.
Always follow the spring compressor manufacturer's
SEE MORE:
Stop / Start Switch
The stop/start switch is located in the Instrument Panel (IP) and is
hardwired
to the Central Junction Box (CJB). When the switch is pressed two signal
lines from the CJB are connected to ground.
AUTO STOP/START WARNING INDICATOR
The auto stop/start warning indicator is located in the Instrumen
Anti-trap protection
Closing a window or roof blind
onto any part of the body can
result in serious injury.
Before closing a window or the
roof blind, make sure no
occupants have any part of their
body in a position where it could
be trapped. Even with an anti-trap
system, death or serious injury
could occur.
Anti-trap
© 2019-2026 Copyright www.lrdisc.com
