Land Rover Discovery Owners & Service Manuals

Land Rover Discovery: Glass, Frames and Mechanisms / Diagnosis and Testing

Land Rover Discovery (2009–2016) Service Manual / Body / Glass, Frames and Mechanisms / Glass, Frames and Mechanisms / Diagnosis and Testing

next pageGlass, Frames and Mechanisms - OperationGlass, Frames and Mechanisms / Diagnosis and Testing - Inspection and Verificationnext page

READ NEXT:

 Glass, Frames and Mechanisms / Diagnosis and Testing - Inspection and Verification

PRINCIPLES OF OPERATION For a detailed description of the Glass, Frames and Mechanisms, refer to the relevant Description and Operation section in the workshop manual. REFER to: Glass, Frames and Mec

 Window Diagnostics - Pinpoint Tests

NOTE: The door window regulator motor can be removed from the regulator. Install a new door window regulator motor only not the complete assembly for this concern. ANTI - RATTLE RETAINING

 Door Window Motor Initialization

NOTES: Make sure that the vehicle battery is fully charged before carrying out this procedure. After the battery has been disconnected or a new window regulator and motor or door module has been

SEE MORE:

 Rear Drive Axle- Differential - Vehicles without- Active Driveline Differential Support Insulator (G1775376) / Removal and Installation

GENERAL EQUIPMENT REMOVAL NOTES: This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct. This procedure contains illustrations showing certain components removed to provide extra clarity. Raise and

 Exhaust - Ingenium i4 2.0l Diesel Catalytic Converter to Turbocharger Clamp (G1964846)/ Removal and Installation

REMOVAL Remove the engine cover. Refer to: Engine Cover - INGENIUM I4 2.0L Diesel (501-05 Interior Trim and Ornamentation, Removal and Installation). Remove the heat shield. Torque: 10 Nm Using suitable cutting/grinding equipment remove the clamp weld at the points illustrated Remove the

© 2019-2026 Copyright www.lrdisc.com