Land Rover Discovery Owners & Service Manuals

Land Rover Discovery: Rear end Sheet Metal Repairs Rear Floor Side Extension (G1770934)

Land Rover Discovery (2009–2016) Service Manual / Body / Body Repairs and General Information / Rear end Sheet Metal Repairs Rear Floor Side Extension (G1770934)

READ NEXT:

 Rear end Sheet Metal Repairs Rear Floor Side Extension (G1770934) - Removal

Removal NOTE: The rear floor side extension is installed in conjunction with: Rear bumper cover Rear bumper Back panel outer Back panel inner Rear lamp panel outer Rear side member lower side

 Rear end Sheet Metal Repairs Rear Floor Side Extension (G1770934) - Installation

Installation Dress the flanges where necessary. Offer up the new rear floor side extension and clamp into position. Check alignment if correct, proceed to next step, if not, rectify and recheck b

 Rear end Sheet Metal Repairs Rear Bumper Retaining Rail (G1770947) / Removal and Installation

REMOVAL NOTE: The rear bumper retaining rail is installed in conjunction with: Rear bumper cover Rear bumper The rear bumper retaining rail is serviced as indicated. Before commencing this pr

SEE MORE:

 Interior Trim and Ornamentation 'B' Pillar Upper Trim Panel (G1785129) / Removal and Installation

PART(S) REMOVAL CAUTION: Do not use tools during this operation, removal of the component(s) must be carried out by hand. NOTES: Removal steps in this procedure may contain installation details. RH illustration shown, LH is similar. Disconnect the battery ground cable. Refer to: Specifications

 Tyre pressures

All tyre pressures, including the spare, should be checked regularly using an accurate pressure gauge, when the tyres are cold. Pressure checks should be carried out only when the tyres are cold, and the vehicle has been stationary for more than 3 hours. A hot tyre at, or below, the reco

© 2019-2026 Copyright www.lrdisc.com