Land Rover Discovery: Rear end Sheet Metal
Repairs Rear
Side Member
Section (G1770933)
READ NEXT:
NOTE:
The rear side member section is installed in conjunction with:
Rear bumper
Rear bumper retaining rail
Rear lamp assembly
Rear lamp panel outer
Back panel outer
Back panel inner
Quarter p
Installation
Dress the flanges where necessary.
Using the old rear side member outer reinforcement and the
measurements as a guide, cut the new rear side member outer
reinforcement on the new
REMOVAL
NOTE:
The rear side member lower side extension is installed in conjunction
with:
Rear bumper cover
Rear bumper
Back panel outer
Back panel inner
Rear lamp panel outer
The rear side
SEE MORE:
REMOVAL
NOTE:
The fender apron panel front section is installed in conjunction with:
Front bumper cover
Hood
Hood hinge
Hood latch panel
Front fender
Fender splash shield
The fender apron panel is serviced as indicated.
Before commencing this procedure make sure that you are aware of
a
CHECK
NOTE:
Left illustration shown, right is similar.
Check the gap and profiles of the fender are correct.
ADJUSTMENT
Remove the rocker panel moulding.
Refer to: Rocker Panel Moulding (501-08 Exterior Trim and
Ornamentation, Removal and Installation).
WARNING:
Make sure to support the vehicle w