Land Rover Discovery: Side Panel Sheet Metal Repairs 'A' Pillar Outer Panel (G1770902)
Land Rover Discovery (2009–2016) Service Manual / Body / Body Repairs and General
Information / Side Panel Sheet
Metal Repairs 'A'
Pillar Outer
Panel (G1770902)
- Side Panel Sheet Metal Repairs 'A' Pillar Outer Panel (G1770902) - Removal
- Side Panel Sheet Metal Repairs 'A' Pillar Outer Panel (G1770902) - Installation
Side Panel Sheet
Metal Repairs 'A'
Pillar
Reinforcement (G1770903) - InstallationSide Panel Sheet
Metal Repairs 'A'
Pillar Outer
Panel (G1770902) - Removal
READ NEXT:
Side Panel Sheet
Metal Repairs 'A'
Pillar Outer
Panel (G1770902) - Removal
NOTE:
The A-pillar outer panel is installed in conjunction with:
Front bumper cover
Hood
Front fender
Fender splash shield
Front door
Instrument panel
Windshield glass
Headliner
Side air cur
Side Panel Sheet
Metal Repairs 'A'
Pillar Outer
Panel (G1770902) -
Installation
Installation
Dress the flanges where necessary.
Mark out the position on the new A-pillar outer panel where the
upper and lower Metal Inert Gas (MIG) welded butt joints are to be
made. Cut t
Roof Sheet Metal
Repairs Windshield
Header Panel (G1770878)
/ Removal and Installation
REMOVAL
NOTE:
The windshield header panel is installed in conjunction with:
Headliner
Roof moulding
Side air curtain module
Roof panel
Roof front panel
Glass roof panel
Windshield glass
T
SEE MORE:
Rear Suspension Wheel
Knuckle (G1775239) / Removal
SPECIAL TOOL(S)
PART(S)
REMOVAL
CAUTIONS:
Nuts and bolts must be tightened with the weight of the vehicle on
the suspension.
Do not allow halfshafts to hang unsupported at one end or joint
damage will occur.
Make sure the halfshaft constant velocity (CV) joints do not over
articulate. Fail
Rear Drive Axle - Differential - Vehicles with- Active Driveline Electric
Hydraulic Pump (G1781303) / Removal and Installation
REMOVAL
NOTE:
Removal steps in this procedure may contain installation details.
WARNING:
Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
NOTE:
Before disconnect any components of the active driveline
hydraulic system, the two pipe port closing valve must be
closed m
© 2019-2025 Copyright www.lrdisc.com
