Land Rover Discovery: Side Panel Sheet Metal Repairs 'A' Pillar Reinforcement (G1770903)
Land Rover Discovery (2009–2016) Service Manual / Body / Body Repairs and General
Information / Side Panel Sheet
Metal Repairs 'A'
Pillar
Reinforcement (G1770903)
- Side Panel Sheet Metal Repairs 'A' Pillar Reinforcement (G1770903) - Removal
- Side Panel Sheet Metal Repairs 'A' Pillar Reinforcement (G1770903) - Installation
Side Panel Sheet
Metal Repairs 'B'
Pillar Outer
Panel (G1770904) - InstallationSide Panel Sheet
Metal Repairs 'A'
Pillar
Reinforcement (G1770903) - Removal
READ NEXT:
Side Panel Sheet
Metal Repairs 'A'
Pillar
Reinforcement (G1770903) - Removal
Removal
NOTE:
The A-pillar reinforcement is installed in conjunction with:
Front bumper cover
Hood
Front fender
Fender splash shield
Front door
Instrument panel
Windshield glass
Headliner
S
Side Panel Sheet
Metal Repairs 'A'
Pillar
Reinforcement (G1770903) - Installation
Dress the flanges where necessary.
Clean and prepare the panel surfaces.
Using the old A-pillar reinforcement as a guide, detach the new Apillar
reinforcement from the ring frame as indicated
SEE MORE:
Clutch Pedal Position Sensor (Manual Ransmission Vehicles Only)
The clutch pedal position sensor provides the ABS control module with a
continuous measure of clutch pedal position.
The clutch pedal position sensor is attached to the clutch master cylinder.
The sensor is a permanent magnet linear contactless displacement type
sensor.
The signal from the clut
Steering Linkage Tie
Rod (G1788230) / Removal and
Installation
SPECIAL TOOL(S)
REMOVAL
NOTES:
Some components shown removed for clarity.
Removal steps in this procedure may contain installation details.
Refer to: Steering Gear Boot (211-03 Steering Linkage, Removal
and Installation).
Special Tool(s): JLR-211-342
CAUTION:
Make sure the steering gear ba
© 2019-2026 Copyright www.lrdisc.com
