Land Rover Discovery: Uni-body, Subframe and Mounting System Front Subframe (G2028440)
Land Rover Discovery (2009–2016) Service Manual / Body / Frame and mounting / Uni-body, Subframe and Mounting
System Front
Subframe (G2028440)
- Uni-body, Subframe and Mounting System Front Subframe (G2028440) - Removal
- Uni-body, Subframe and Mounting System Front Subframe (G2028440) - Installation
READ NEXT:
Uni-body, Subframe and Mounting
System Front
Subframe (G2028440)
- Removal
SPECIAL TOOL(S)
GENERAL EQUIPMENT
PART(S)
STEP REPLACE PART / RENEW PART PART NAME
Removal
CAUTION:
The final tightening of the suspension components must be carried
out with the vehicle on its
Uni-body, Subframe and Mounting
System Front
Subframe (G2028440)
- Installation
Installation
NOTES:
Steps 1 to 5 must only be performed to the components were
previously removed.
Steps 14 to 20 must be performed to the components on both
sides of the vehicle.
All vehicles
I
Uni-body, Subframe and Mounting
System Front
Subframe Front
Bushing (G1348232) / Removal and installation
SPECIAL TOOL(S)
REMOVAL
NOTE:
Some variation in the illustrations may occur, but the essential
information is always correct.
WARNING:
Make sure to support the vehicle with axle stands.
Raise and su
SEE MORE:
Hazard Warning Lamps
The hazard warning lamps are controlled by a non-latching switch in the
centre of the instrument panel. The hazard warning lamps operate at all
times when selected and are not dependent on the ignition power mode.
When the hazard warning lamps are selected on, all of the turn signal
indicators oper
Front Safety Belt
Buckle (G1780743) / Removal and
Installation
REMOVAL
WARNINGS:
To avoid accidental deployment and possible personal injury,
the
backup power supply must be depleted before repairing or
replacing any air bag supplemental restraint system (SRS)
components. To deplete the backup power supply energy,
disconnect the battery ground cable and
© 2019-2025 Copyright www.lrdisc.com
