Land Rover Discovery: Driveshaft - Ingenium I4 2.0l Diesel, Vehicles with- active Driveline (G1890848)
Land Rover Discovery (2009–2016) Service Manual / Chassis / Chassis-Driveline / Driveshaft - Ingenium I4 2.0l Diesel, Vehicles with- active Driveline
(G1890848)
- Driveshaft - Ingenium I4 2.0l Diesel, Vehicles with- active Driveline (G1890848) - Removal
- Driveshaft - Ingenium i4 2.0l Diesel, Vehicles with- active Driveline (G1890848) - Installation
Chassis-DrivelineDriveshaft - Ingenium I4 2.0l Diesel, Vehicles with- active Driveline
(G1890848) - Removal
READ NEXT:
Driveshaft - Ingenium I4 2.0l Diesel, Vehicles with- active Driveline
(G1890848) - Removal
PART(S)
REMOVAL
WARNING:
Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
Refer to: Exhaust System (309-00C Exhaust System - INGENIUM I4
2.0L Diesel, Removal and
Driveshaft - Ingenium i4 2.0l Diesel, Vehicles with- active Driveline
(G1890848) - Installation
Installation
Torque: 25 Nm
NOTES:
Do not tighten at this stage.
This step requires the aid of another technician.
NOTE:
Do not tighten at this stage.
NOTES:
Do not tighten at this stage.
SEE MORE:
Exterior Trim and Ornamentation
Rear Spoiler (G1791772)
- Installation
Installation
NOTE:
Position cloth to collect fluid spillage.
CAUTION:
Only tighten the bolts finger-tight at this stage.
CAUTION:
Only tighten the nuts finger-tight at this stage.
CAUTION:
Make sure that the gap is even between the rear spoiler and
the rear quarter panel moulding and the r
Rear end Sheet Metal
Repairs Spare
Wheel - Vehicles
Without - 7
Seats (G1770929)
- Installation
Installation
Dress the flanges where necessary.
Offer up the new spare wheel well and clamp into position. Check
alignment, if correct, proceed to next step, if not, rectify and
recheck before proceeding.
Drill holes where the MIG plug welds are to be installed as
indicated.
Remove the s
© 2019-2026 Copyright www.lrdisc.com
