Land Rover Discovery Owners & Service Manuals

Land Rover Discovery: Front end Sheet Metal Repairs Suspension Top Mount (G1770868)

Land Rover Discovery (2009–2016) Service Manual / Body / Body Repairs and General Information / Front end Sheet Metal Repairs Suspension Top Mount (G1770868)

READ NEXT:

 Front end Sheet Metal Repairs Suspension Top Mount  (G1770868) - Removal

Removal NOTE: The suspension top mount is installed in conjunction with: Front bumper cover Front bumper Hood Hood latch panel Front fender Front fender splash shield Fender apron panel Fende

 Front end Sheet Metal Repairs Suspension Top Mount  (G1770868) - Installation

Installation NOTE: Make sure that the drilled out spot welds are installed with metal inert gas (MIG) plug welds in the same quantities. Using the old suspension top mount for reference prepare the

 Front end Sheet Metal Repairs Front Side Member and Suspension Top Mount Assembly (G1770869)

SEE MORE:

 Rear Drive Axle- Differential - Vehicles with- Active Driveline Hydraulic System Fluid Level Check (G2159540) / General Procedures

CHECK NOTES: This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct. This procedure contains illustrations showing certain components removed to provide extra clarity. Raise and support the vehicle.

 All Wheel Drive Control Module (AWDCM) / Description

The AWDCM is located at the front right side of the RDU, adjacent to the drive flange. The AWDCM is attached to the RDU casing and secured with screws. Two electrical connectors provide the interface between the AWD valve block and the vehicle systems. The upper connector provides the connections

© 2019-2026 Copyright www.lrdisc.com