Land Rover Discovery: Rear Drive Axle - Differential - Vehicles with- Active Driveline Drive Pinion Seal (G1781297)
Land Rover Discovery (2009–2016) Service Manual / Chassis / Chassis-Driveline / Rear Drive Axle - Differential - Vehicles with- Active Driveline Drive Pinion
Seal (G1781297)
- Rear Drive Axle - Differential - Vehicles with- Active Driveline Drive Pinion Seal (G1781297) - Removal
- Rear Drive Axle - Differential - Vehicles with- Active Driveline Drive Pinion Seal (G1781297) - Installation
Rear Drive Axle - Differential - Vehicles with- Active Driveline Drive Pinion
Flange (G1781296) - InstallationRear Drive Axle - Differential - Vehicles with- Active Driveline Drive Pinion
Seal (G1781297) - Removal
READ NEXT:
Rear Drive Axle - Differential - Vehicles with- Active Driveline Drive Pinion
Seal (G1781297) - Removal
SPECIAL TOOL(S)
PART(S)
REMOVAL
NOTE:
Some variation in the illustrations may occur, but the essential
information is always correct.
WARNING:
Make sure to support the vehicle with axle stands.
R
Rear Drive Axle - Differential - Vehicles with- Active Driveline Drive Pinion
Seal (G1781297) - Installation
Installation
CAUTION:
Make sure new bolts are installed.
Renew Part: Differential case rear bolts.
Refer to: Fuel Tank (310-01A Fuel Tank and Lines - TD4 2.2L Diesel,
Removal and Installation)
Rear Drive Axle - Differential - Vehicles with- Active Driveline Electric
Hydraulic Pump (G1781303) / Removal and Installation
REMOVAL
NOTE:
Removal steps in this procedure may contain installation details.
WARNING:
Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
NOTE:
Before disconnect any c
SEE MORE:
Fuel Charging and Controls
- Ingenium i4 2.0l Diesel
Fuel Injector
Fuel Return
Line (G1875962) / Installation
Install the fuel injector fuel return line.
NOTE:
Remove and discard the blanking cap.
Connect the fuel pump fuel return line.
NOTE:
Remove and discard the blanking caps.
Connect the fuel rail fuel supply line.
Attach the fuel return line and connect the fuel line retaining clip.
NOTE:
R
Cylinder Block Components
M6 bolt (13 off), M10 bolt (1 off)
Engine front cover
Cylinder block
Lower timing chain cover
M8 screw (16 off)
M10 bolt (8 off)
Dual mass flywheel (manual transmission) or drive plate (Automatic
Transmission)
Right dynamic balancer
Left dynamic balancer
Thrust washer (2 off)
Upper m
© 2019-2026 Copyright www.lrdisc.com
