Land Rover Discovery Owners & Service Manuals

Land Rover Discovery: Front Row Seat Backrest Blower (G1780403) / Removal and Installation

Land Rover Discovery (2009–2016) Service Manual / Body / Seating / Front Row Seat Backrest Blower (G1780403) / Removal and Installation

REMOVAL

NOTES:

  • Some variation in the illustrations may occur, but the essential information is always correct.
  • Removal steps in this procedure may contain installation details.

Refer to: Front Seat - Vehicles With: Power Seats (501-10, Removal and Installation).

Front row seat backrest blower (G1780403) removal and installation

Front row seat backrest blower (G1780403) removal and installation

Front row seat backrest blower (G1780403) removal and installation

Front row seat backrest blower (G1780403) removal and installation

Front row seat backrest blower (G1780403) removal and installation

Front row seat backrest blower (G1780403) removal and installation

Front row seat backrest blower (G1780403) removal and installation

Front row seat backrest blower (G1780403) removal and installation

Front row seat backrest blower (G1780403) removal and installation

INSTALLATION

To install, reverse the removal procedure.

    next pageFront Row Seat - Vehicles with- power Seats (G1780390) / Removal and InstallationFront Row Seat Backrest Cover - Vehicles with- power Seats (G1780396) / Removal and Installationnext page

    READ NEXT:

     Front Row Seat Backrest Cover - Vehicles with- power Seats (G1780396) / Removal and Installation

    REMOVAL WARNINGS: To avoid accidental deployment, the restraints control module backup power supply must be depleted. Wait at least two minutes after disconnecting the battery ground cable(s) befo

     Front Row Seat Control Switchpack (G1780397) / Removal and Installation

    REMOVAL NOTES: Removal steps in this procedure may contain installation details. Some variation in the illustrations may occur, but the essential information is always correct. Refer to: Front Se

     Front Row Seat Cushion Blower (G1780402) / Removal and Installation

    REMOVAL NOTES: Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this procedure may contain installation details. Refer to: Front Se

    SEE MORE:

     Engine Emission Control - Ingenium i4 2.0l Diesel Low Pressure Exhaust Gas Recirculation Valve (G1875911) / Removal and Installation

    REMOVAL NOTE: Removal steps in this procedure may contain installation details. Refer to: Engine Cover - INGENIUM I4 2.0L Diesel (501-05 Interior Trim and Ornamentation, Removal and Installation). Torque: Clamp 3.5 Nm Bolt 8 Nm NOTE: Remove and discard the O-ring seal. Torque: 12 Nm Torque:

     Anti-lock Control Anti-lock Brake System Module (G1807249) / Removal and Installation

    REMOVAL CAUTIONS: If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water. Make sure that all openings are sealed. Use new blanking caps. NOTES: Removal steps in this procedure may contain installation details. LHD illustration shown, RHD

    © 2019-2025 Copyright www.lrdisc.com